Step by Step
1. Open Inventor
2. Follow step by step on designing it in inventor
3. Once designed open in fusion 360
4. Create a set up to cut out your design
5. save the design to flash drive
6. open on the computer with the cnc mill
7. Run the mill
8. Your done, good job
2. Follow step by step on designing it in inventor
3. Once designed open in fusion 360
4. Create a set up to cut out your design
5. save the design to flash drive
6. open on the computer with the cnc mill
7. Run the mill
8. Your done, good job
What I learned
With this project I learned to use the cnc mill, similar to the router I used the same program fusion 360 which I was familiar with already so it went a little easier but over all it still was a learning process.